Elecraft released a new small size qrp transceiver about half the size of the KX3 series.

Some technical differences with the KX3 is that the KX2 is 80-10meter where the KX3 has also 160m, 6m and optional a 2m add on.

This is a cool piece of hardware for your projects.

This is a mixed signal oscilloscope with a small OLED display, an integrated waveform generator and a 8 channel logic analyzer combined, everything on a single small DIP module.

Just plug it into a breadboard or put some headers on your PCB and voila.

• Read more about Oscilloscope on a chip ! Primary tabs

Know how you sometimes need to measure things but you would actually need very long probes ?

Well this is the solution !

the mooshimeter can measure and display the results on your phone

You can also log the data even over long periods ( up to 6 months)

check it out:

• Read more about Multimeter with a remote display via an App

This is actually a crowd-funded project that will soon be available.

At this point pre-ordering can be done and the first batch has been shipped if I'm correct.

Trying to get the latest info on this one.

These are the frequency ranges of the board: 134-174MHz, 200-260MHz, 400-520MHz

You want some easy way to integrate an arduino on your PCB ?

Check this out : a minuscule form factor Arduino in an 8-pin DIP format. Built with an ATtiny85, the board has an area of just under 75 square millimeters (less than 8 mm x 10 mm). If you add the USB port, it still comes in at just over 144 square millimeters.

• Read more about An arduino in an 8-pin DIL housing ?